95 altima
5 posters
Page 1 of 1
95 altima
setting up an oil return line from my turbo.
You cannot even see the turbo oil outlet....
http://awdu13.wordpress.com/2012/04/29/build-update/
You cannot even see the turbo oil outlet....
http://awdu13.wordpress.com/2012/04/29/build-update/
Last edited by awdaltima on Wed May 30, 2012 6:46 pm; edited 1 time in total
awdaltima- TTS Rookie
- Join date : 2011-06-24
Posts : 36
Re: 95 altima
I think I heard about this project a while back, unless your not the only one doing this to the same model. How far along are you now?
Hydrolikz- TTS VP
- Location : Low To The Ground
Age : 111
Join date : 2009-09-26
Posts : 4272
Re: 95 altima
I didn't put a lubricant on when I was trying to get this -6 hose end onto my lines...
my loss.
there goes 10 bucks down the drain.
make sure you use a lot of fap fap fap lube!!!!
http://awdu13.wordpress.com/?attachment_id=608
my loss.
there goes 10 bucks down the drain.
make sure you use a lot of fap fap fap lube!!!!
http://awdu13.wordpress.com/?attachment_id=608
awdaltima- TTS Rookie
- Join date : 2011-06-24
Posts : 36
Re: 95 altima
what do you guys think about matte silver?
does it look like primer?
does it look like primer?
awdaltima- TTS Rookie
- Join date : 2011-06-24
Posts : 36
Re: 95 altima
unique. grille looks good
just G- TTS Moderator
- Location : Downtown T.O.
Age : 38
Join date : 2009-09-27
Posts : 2332
Re: 95 altima
first go @ carbon fiber
wet lay x 2
1st trimming
The trimming leaves a rough edge. I'm going to need another layer of resin to level everything out and then i can sand/buff it for depth.
wet lay x 2
1st trimming
The trimming leaves a rough edge. I'm going to need another layer of resin to level everything out and then i can sand/buff it for depth.
awdaltima- TTS Rookie
- Join date : 2011-06-24
Posts : 36
Re: 95 altima
That's some sick work there.
Hydrolikz- TTS VP
- Location : Low To The Ground
Age : 111
Join date : 2009-09-26
Posts : 4272
Re: 95 altima
Yes. I did this myself. It's my first attempt. The 2nd door panel will look much better. That being said, I will most likely have to redo this one. It looks like a DYI job and I'm not happy about that.
awdaltima- TTS Rookie
- Join date : 2011-06-24
Posts : 36
Re: 95 altima
Not too shabby for a first attempt!
Hydrolikz- TTS VP
- Location : Low To The Ground
Age : 111
Join date : 2009-09-26
Posts : 4272
Similar topics
» Lol @ Altima
» Altima Coupe 3.5
» VIP Status Altima
» twista's 07 Altima
» Jfrzy's 4th Gen Altima Sedan
» Altima Coupe 3.5
» VIP Status Altima
» twista's 07 Altima
» Jfrzy's 4th Gen Altima Sedan
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum